TEST
ACTION
APPLICABILITY
10
Turn the ignition off.
Disconnect the applicable Temperature Sensor harness connector.
Disconnect the PCM harness connector.
CAUTION: DO NOT PROBE THE PCM HARNESS CONNECTORS. PROBING
THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM TERMI-
NALS RESULTING IN POOR TERMINAL TO PIN CONNECTION. INSTALL
MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.
Measure the resistance of the Sensor ground circuit from the Ambient Air Temper-
ature Sensor harness connector to the appropriate terminal of special tool #8815.
Is the resistance below 5.0 ohms?
All
Yes
→ NOTE: Before continuing, check the PCM harness connector
terminals for corrosion, damage, or terminal push out. Repair as
necessary. Replace and program the Powertrain Contorl Module
in accordance with the Service Information.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
No
→ Repair the open in the Sensor ground circuit.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
11
Turn the ignition off.
Disconnect the applicable Temperature Sensor harness connector.
Disconnect the PCM harness connector.
Measure the resistance between ground and the Signal circuit in the Temperature
harness connector.
Is the resistance below 100 ohms?
All
Yes
→ Repair the short to ground in the Signal circuit.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
No
→ Go To 12
12
Turn the ignition off.
Disconnect the applicable Temperature Sensor harness connector.
Disconnect the PCM harness connector.
Measure the resistance between the Signal circuit and the Sensor ground circuit in
the Temperature Sensor harness connector.
Is the resistance below 100 ohms?
All
Yes
→ Repair the Sensor ground shorted to the Signal circuit.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
No
→ NOTE: Before continuing, check the PCM harness connector
terminals for corrosion, damage or terminal push out. Repair as
necessary. Replace and program the Powertrain Control Module
in accordance with the Service Information.
Perform POWERTRAIN VERIFICATION TEST VER - 5.
258
DRIVEABILITY - NGC
P1115-GENERAL TEMP SENSOR PERFORMANCE —
Continued