|
|
Symptom: PINCH SENSOR CIRCUIT OPEN When Monitored and Set Condition: PINCH SENSOR CIRCUIT OPEN When Monitored: Whenever the Power Liftgate is operating. Set Condition: The power liftgate module has detected the pinch sensor circuit voltage is above 4.6 volts. POSSIBLE CAUSES DTC PRESENT POWER LIFTGATE MODULE - PINCH SENSOR OPEN RIGHT PINCH SENSOR SIGNAL WIRE OPEN PINCH SENSOR GROUND OPEN RIGHT PINCH SENSOR OPEN LEFT PINCH SENSOR OPEN RIGHT PINCH SENSOR SIGNAL WIRE OPEN TEST ACTION APPLICABILITY 1 With the DRBIII t, record and erase DTC’s. Turn the ignition off, wait 10 seconds, then turn the ignition on. t, read DTCs. Does the DRBIII t display PINCH SENSOR CIRCUIT OPEN? All Yes → Go To 2 No → Using the wiring diagram/schematic as a guide, inspect the wiring and connectors for an intermittent condition. 2 Disconnect the Power Liftgate Module C2 connector. All No → Go To 3 Yes → Replace the Power Liftgate Module. Perform BODY VERIFICATION TEST - VER 1. 1017 POWER DOORS - LIFTGATE |