TEST
ACTION
APPLICABILITY
2
WARNING: TURN IGNITION OFF, DISCONNECT THE BATTERY AND WAIT
TWO MINUTES BEFORE PROCEEDING.
Disconnect the Left Curtain or Seat Airbag connector.
WARNING: DO NOT PLACE AN INTACT UNDEPLOYED CURTAIN AIRBAG
FACE DOWN ON A HARD SURFACE, THE AIRBAG WILL PROPEL INTO
THE AIR IF ACCIDENTALLY DEPLOYED, AND COULD RESULT IN SERI-
OUS OR FATAL INJURY.
Connect the appropriate Load Tool to the Left Curtain or Seat Airbag connector.
WARNING: TURN IGNITION ON, THEN RECONNECT THE BATTERY.
NOTE: Check connectors - Clean and repair as necessary.
With the DRBIII
t, read active Airbag Control Module DTC’s.
Does the DRBIII
t show LEFT CURTAIN OR SEAT SQUIB SEAT OPEN?
All
Yes
→ Go To 3
No
→ Replace Left Curtain or Seat Airbag in accordance with the
Service Information.
Perform __AIRBAG VERIFICATION TEST - VER 1.
3
WARNING: TURN IGNITION OFF, DISCONNECT THE BATTERY AND WAIT
TWO MINUTES BEFORE PROCEEDING.
Disconnect the Airbag Load Tool from the Left Curtain or Seat Airbag connector.
Disconnect the Airbag Control Module Connector(s).
NOTE: Check connectors - Clean and repair as necessary.
Connect the appropriate Load Tool ACM Adapter to the Airbag Control Module
connector(s).
Measure the resistance of the Left Curtain or Seat Squib Line 1 and Line 2 circuit.
Is the resistance below 1.0 ohms on both circuits?
All
Yes
→ Replace the Airbag Control Module in accordance with the Service
information. WARNING: IF THE AIRBAG CONTROL MODULE
IS DROPPED AT ANY TIME, IT MUST BE REPLACED.
Perform __AIRBAG VERIFICATION TEST - VER 1.
No
→ Repair open or high resistance in the Left Curtain or Seat Squib
Line 1 or Line 2 circuits.
Perform __AIRBAG VERIFICATION TEST - VER 1.
113
AIRBAG
LEFT CURTAIN OR SEAT SQUIB CIRCUIT OPEN —
Continued