Index Chrysler Chrysler 300M / Concorde / Interpid / LHS, Dodge Interpid - service repair manual 2000-2004 year
|
|
(d) Press and hold the bracket in place for at least one minute. NOTE: Verify that the mirror support bracket is cor- (7) Allow the adhesive to cure for 8-10 minutes. Remove any excess adhesive with an alcohol-damp- (8) Allow the adhesive to cure for an additional 8-10 minutes before installing the mirror. REAR SEAT GRAB HANDLE/ REMOVAL (1) Pull down coat hook. from behind coat hook. (3) Pull and hold assist handle down. roof (Fig. 24). (5) Remove assist handle from roof. to back of assist handle base. (7) Disconnect reading lamp switch from slot on back of assist handle base. (8) Remove assist handle from vehicle. INSTALLATION (1) Place assist handle in position on vehicle. of assist handle base. (3) Engage clips attaching reading lamp socket to back of assist handle base. (4) Place assist handle in position on roof. roof. (7) Install screw behind coat hook attaching assist handle to roof. SUN VISOR REMOVAL All vehicles with driver and passenger side air bags must have a colored coded five Bullet point air- (1) Remove screw attaching inboard visor retainer to over head. (Fig. 25). (2) Remove screws attaching outboard visor pivot base to roof. (3) Disconnect visor vanity lamp wire connector, if equipped. (4) Remove visor from vehicle. INSTALLATION All vehicles with driver and passenger side airbags must have a colored coded five bullet point airbag (1) Engage visor vanity lamp wire connector, if equipped. (2) Place visor in position on header. base to over head. (4) Install screw attaching inboard visor retainer to over head. Fig. 24 REAR ASSIST HANDLE AND READING LAMP 1 - COAT HOOK Fig. 25 SUN VISOR 1 - VISOR PIVOT BASE LH INTERIOR 23 - 73 REAR VIEW MIRROR (Continued) |