Index Chrysler Chrysler 300M / Concorde / Interpid / LHS, Dodge Interpid - service repair manual 2000-2004 year
|
|
WINDOW REGULATOR REMOVAL (1) Remove flag cover, door trim panel, water shield as necessary, and pull cup support bracket. (2) Slide glass from regulator roller channel (Fig. 12). (3) Disconnect power window motor wire connec- tor. (4) Loosen screw attaching regulator scissor chan- nel to door panel. (5) Remove screw and bolt heads from keyhole slots in door panel. (6) Loosen bolt attaching regulator support brace to door panel. (7) Loosen bolts attaching regulator to door panel. end of roller channel through access hole in door INSTALLATION (1) Insert roller channel through access hole in door panel. (2) Insert bolt and screw heads through key hole slots in door panel. (3) Tighten bolts attaching regulator to door panel. to door panel. (5) Tighten screw to attach regulator scissor chan- nel to door panel. (6) Connect power window motor wire connector. door trim panel and flag cover. CABLE - REMOTE LOCK REMOVAL (1) Open the front door. to 23 - BODY/DOORS - REAR/TRIM PANEL - (6) Remove the support bracket screws. cable. (8) Remove support tie straps, if equipped. INSTALLATION (1) Install the cable into the door and through the hole in the door shut face. (2) Install and tighten the cable nut. knob. (4) Tighten the lock nut. clip. (6) Install the support bracket screws and verify correct actuator operation. (7) Loosen the support bracket screws and adjust the cable if necessary. (8) Replace any support tie straps, if equipped. (Refer to 23 - BODY/DOORS - REAR/TRIM PANEL - Fig. 12 REAR DOOR WINDOW REGULATOR 1 - GLASS LH DOORS - REAR 23 - 33 |