Index Chrysler Chrysler 300M / Concorde / Interpid / LHS, Dodge Interpid - service repair manual 2000-2004 year
|
|
UNDERHOOD LAMP - POLICE REMOVAL (1) Open hood, disconnect and isolate the battery negative remote terminal or pull fuse Y in the PDC. (2) Insert a small flat blade in access slot between the lamp base and lamp lens. (3) Lift the lamp lens upward and remove the lamp lens (Fig. 64). (4) Depress bulb terminal inward (Fig. 65) to release bulb. INSTALLATION (1) Engage the replacement bulb wire loop to ter- minal closest to lamp base wire connector. (2) Depress the opposite terminal inward and engage the remaining bulb wire loop. (3) Position the lamp lens on the lamp base and press into place. (4) Connect the battery negative remote cable or reinsert fuse Y in the PDC. (5) Verify system and vehicle operation. UNDERHOOD LAMP UNIT - REMOVAL (1) Open hood, disconnect and isolate the battery negative remote terminal or pull fuse Y in the PDC. (2) Disconnect the wire harness connector from lamp unit. (3) Remove the push-pin fastener attaching under- hood lamp unit to inner hood panel (Fig. 66). (4) Remove the underhood lamp unit from the vehicle. Fig. 63 FRONT PARKING, SIDE MARKER/TURN SIGNAL LAMP UNIT Fig. 64 UNDERHOOD LAMP LENS 1 - LAMP Fig. 65 UNDERHOOD LAMP 1 - BULB LH LAMPS/LIGHTING - EXTERIOR 8L - 45 TURN SIGNAL LAMP UNIT - CONCORDE/300M (Continued) |