Loader Bobcat 773. Manual - part 2
P–10650
A
vi
773 BICS Loader
Service Manual
FIRE PREVENTION
The loader has several components that are at high temperature under normal operating conditions. The primary source of
high temperatures is the engine and exhaust system. The electrical system, if damaged or incorrectly maintained, can be a
source of arcs or sparks.
Flammable debris (leaves, straw, etc.) must be removed regularly. If flammable debris is allowed to accumulate, it will increase
the fire hazard. The loader must be cleaned as often as necessary to avoid this accumulation. Flammable debris in the engine
compartment is a fire hazard when the loader is parked with a hot engine.
The spark arrestor muffler is designed to control the emission of hot particles from the engine and exhaust system, but the
muffler and the exhaust gases are still hot.
•
Do not use the Bobcat loader where exhaust, arcs, sparks or hot components can contact flammable material, explosive
dust or gases.
•
The engine compartment and engine cooling system must be inspected every day and cleaned if necessary to prevent fire
hazard and overheating.
•
Check all electrical wiring and connections for damage. Keep the battery terminals clean and tight. Repair or replace any
damaged part.
•
Check fuel and hydraulic tubes, hoses and fittings for damage and leakage. Never use open flame or bare skin to check
for leaks. Tighten or replace any parts that show leakage. Always clean fluid spills. Do not use gasoline or diesel fuel for
cleaning parts. Use commercial nonflammable solvents.
•
Do not use ether or starting fluids on this engine. It has glow plugs. These starting aids can cause explosion and injure you
or bystanders.
•
Always clean the loader and disconnect the battery before doing any welding. Cover rubber hoses, battery and all other
flammable parts. Keep a fire extinguisher near the loader when welding. Have good ventilation when grinding or welding
painted parts. Wear dust mask when grinding painted parts. Toxic dust or gas can be produced.
•
Stop the engine and let it cool before adding fuel. No smoking!
•
Use the procedure in the Operation & Maintenance Manual for connecting the battery.
•
Use the procedure in the Operation & Maintenance Manual for cleaning the spark arrestor muffler.
•
Know where fire extinguishers and first aid kits are located and how to use them.
A fire extinguisher is available from your Bobcat dealer. The fire extinguisher can be installed in the location shown [A].
SI06–0301