|
|
1. Turn the ignition switch ON (II). 2. Clear the DTC with the HDS. 3. Turn the ignition switch OFF. 4. Remove the fuel fill cap. 5. Turn the ignition switch ON (II). 6. Check the FTP SENSOR in the DATA LIST with the HDS. Is about -7.3 kPa (-55 mm Hg, -2.16 in. Hg), 0.3 V, or less indicated? YES: Go to step 10 . NO: Go to step 7. 7. Install the fuel fill cap. 8. Start the engine. 9. Monitor the OBD STATUS for DTC P0452 in the DTCs MENU with the HDS. Does the screen indicate FAILED? YES: Go to step 10. NO: If the screen indicates PASSED, intermittent failure, system is OK at this time. If the 10. Turn the ignition switch OFF. 11. Disconnect the FTP sensor 3P connector. 12. Turn the ignition switch ON (II). 13. Check the FTP SENSOR in the DATA LIST with the HDS. Is about 7.3 kPa (54.7 mm Hg, 2.15 in. Hg), 4.90 V indicated? YES: Go to step 20 . NO: Go to step 14. 14. Measure voltage between FTP sensor 3P connector terminal No. 1 and body ground. Is there about 5 V? YES: Go to step 16 . NO: Go to step 15.
2004 Acura TSX 2004 ENGINE PERFORMANCE EVAP System - TSX
|