|
|
12. Connect the stabilizer links (see STABILIZER LINK ). 13. Install the splash shield (see step 25 of TRANSMISSION INSTALLATION ). 14. Lower the hoist. 15. Tighten the front mount bolt, then install the front mount stop (see step 3 of ENGINE INSTALLATION ). 16. Tighten the rear mount bolt, then install the rear mount stop (see step 4 of ENGINE INSTALLATION ). 17. After assembly, wait at least 30 minutes before filling the engine with oil. TRANSMISSION END CRANKSHAFT SEAL INSTALLATION - IN CAR Special Tools Required: z Driver 07749-0010000 z Oil seal driver attachment 96 07ZAD-PNAA100 1. Clean and dry the crankshaft oil seal housing. 2. Use the special tools to drive a NEW oil seal squarely into the block to the specified installed height.
2004 Acura TSX 2004 ENGINES 2.4L DOHC VTEC - TSX
|