|
|
Fig. 203: Driving Out The Pistons 15. To avoid mix up on reassembly, mark each piston/connecting rod assembly with its cylinder number. 16. Reinstall the connecting rod bearings and caps after removing each piston/connecting rod assembly. 17. Reinstall the lower block and bearings on the engine in the proper order. CRANKSHAFT INSPECTION Out-of-Round & Taper 1. Remove the crankshaft from the cylinder block (see CRANKSHAFT & PISTON REMOVAL ). 2. Clean the crankshaft oil passages with pipe cleaners or a suitable brush. 3. Clean the keyway and threads. 4. Measure out-of round at the middle of each rod and main journal in two places. The difference between measurements on each journal must not be more than the service limit. Journal Out-Of-Round: NOTE: The existing number on the connecting rod does not indicate its position
2004 Acura TSX 2004 ENGINES 2.4L DOHC VTEC - TSX
|