Porshe 911 (997). Manual - part 861

 

  Index      Hummer     Porshe 911 997 series - service repair manual 2004-2008 year

 

Search            

 

 

 

 

 

 

 

 

 

Content   ..  859  860  861  862   ..

 

 

Porshe 911 (997). Manual - part 861

 

 

Si l'erreur passe inaperçue, on court le risque d'exécuter certaines opérations de
manière incorrecte pouvant conduire à des dommages corporels et matériels.

• 

→ Comparez impérativement pour cette raison les impressions papier avec l'affichage à l'écran.
Corrigez-les en cas d'erreur de manière à reproduire correctement l'affichage à l'écran.

ATTENZIONE

Pericolo di perdita dell'abbinamento testo-immagine nella stampa.

Per motivi tecnici non è escluso che, nonostante la rappresentazione sullo schermo
risulti perfetta, durante la stampa venga persa la corrispondenza fra testo e
relativa immagine.

• 

Se tale difetto non viene rilevato vi è il pericolo che i lavori non siano eseguiti
correttamente; ciò può avere come conseguenza lesioni e danneggiamenti.

• 

→ Per questo motivo, dopo la stampa è assolutamente necessario confrontare le stampe con la
rappresentazione sullo schermo. In caso di errore si prega di correggere le stampe, così da
garantire la riproduzione esatta della rappresentazione sullo schermo.

ADVERTENCIA

Al imprimir se corre el riesgo de perder la correcta asignación de las figuras al texto.

Por motivos técnicos, por el momento no se puede descartar que, aun siendo
correcta la imagen que aparezca en la pantalla, al imprimir se pierda la
correlación entre el texto y la figura correspondiente.

• 

Si este error pasara desapercibido, existe el riesgo de que los trabajos no se
ejecuten de forma correcta y, por tanto, se produzcan daños personales y
materiales.

• 

→ Por ello le rogamos que tras el proceso de impresión compare siempre las copias impresas con
la imagen de la pantalla. En caso de error, corrija las copias impresas de forma que se
correspondan con el contenido de la imagen de la pantalla.

Diagnostic system: reading out fault memory and activating systems

Subsequent work on compressor-condenser line

3601

- Preliminary work
- Removing compressor-evaporator line
- Installing compressor-evaporator line
- Subsequent work

Preliminary work

Preliminary work on compressor-evaporator line

Drain refrigerant. → 870317 Draining and filling in refrigerant - chapter on "draining"
Remove drive belt . →  21 Removing and installing drive belt - removing.
Unscrew compressor from engine block. → 873419 Removing and installing compressor

Removing compressor-evaporator line

Removing compressor-evaporator line

Note

Close off all lines and connections using suitable plugs during removal.
Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if
necessary.

Installation Location:

3602

Installation position

B

- Compressor-evaporator line

Unscrewing fastening screw

1. Unscrew the fastening screw -1- on the compressor.

Fastening screw at disconnection point

2. Unscrew the fastening screw -3- at the disconnection point and remove the line from the engine

compartment.

Diagnostic system: reading out fault memory and activating systems

Removing compressor-evaporator line

3603

Installing compressor-evaporator line

Installing compressor-evaporator line

Note

Before re-installing the component, check the O-rings of the refrigerant lines for damage and replaced them if
necessary.
Wet the O-rings of the refrigerant lines with refrigerant oil.
Do not open the plugs for the lines and connections until shortly before installation.

Disconnection point in engine compartment

1. Carefully insert the line into the engine-compartment disconnection point and fasten with the fastening

screw -3- . → Tightening torque: 14 (10.5 ftlb.) Nm

Tightening fastening screw

2. Push the line on and fasten it with the fastening screw -1- . → Tightening torque: 21 (16 ftlb.) Nm

Subsequent work

Diagnostic system: reading out fault memory and activating systems

 Installing compressor-evaporator line

3604

 

 

 

 

 

 

 

Content   ..  859  860  861  862   ..