|
|
Fastening cover for backrest at bottom 6. Press cover for backrest -1- into the backrest shell -2- lower left and right using a screwdriver -3- . Subsequent work Removing creases in the cover ATTENTION Danger of material damage if excessive heat is applied. → If creases have formed, only short partial warming with the hot-air gun is permissible. → The hot-air temperature of approx. 50 degrees Celsius (122 Fahrenheit) must always be observed. If creases have formed in areas of the cover, partially heat them with the hot-air gun and smooth out with the Subsequent work 1. Install control button for backrest release at right and left. → 723119 Removing and installing control button for backrest release - chapter on "Installing" 2. Install cover for backrest. → 722619 Removing and installing cover for backrest - chapter on 4. Install front seat. → 720119 Removing and installing front seat - chapter on "Installing" [997310 997320 997610 997620]→ 720119 Removing and installing front seat - chapter on "Installing" Subsequent work 2. Install front seat. → 720119 Removing and installing front seat - chapter on "Installing" [997310 997320 997610 997620]→ 720119 Removing and installing front seat - chapter on "Installing" 997310, 997311, 997320, 997321, 997610, 997611, 997620, 997621 Diagnostic system: reading out fault memory and activating systems Subsequent work 3413 |