Porshe 911 (997). Manual - part 695

Removing frame for roll-over protection system

Removing frame for roll-over protection system

Installation Location:

Installation position of frame for roll-over protection system

Disconnecting plug connections

1. Press in locking tabs -arrows A- and pull plug connections -1- off wire harness for roll-over

protection system -arrow B- .

Diagnostic system: reading out fault memory and activating systems

Preliminary work

2937

Removing frame for roll-over protection system

2. Unscrew fastening screw -1- and fastening nuts -2- from Z support -3- .

3. Unscrew fastening screws -4- and carefully remove frame for roll-over protection system -5- upwards out

of the vehicle.

Installing frame for roll-over protection system

Installing frame for roll-over protection system

Installation Location:

Installation position of frame for roll-over protection system

Diagnostic system: reading out fault memory and activating systems

Removing frame for roll-over protection system

2938

Removing frame for roll-over protection system

1. Carefully position frame for roll-over protection system -5- on the vehicle. Screw in fastening screws -1,

4-

 and fastening nuts partially by hand.

Adjusting frame for roll-over protection system

Note

To reduce adjustment work to a minimum when assembling convertible-top components, the frame for the
roll-over protection system must be positioned according to the dimension shown.

2. Move frame for roll-over protection system -5- to adjust it by dimension -X- → Adjustment value: 491

mm +/-1 mm

 .

3. Screw in fastening screw -1- and fastening nuts -2- on rear Z support -3- . Tightening torque →

Tightening torque: 45 (33 ftlb.) Nm → Tightening torque: 45 (33 ftlb.) Nm

4. Screw down fastening screw -4- on frame for roll-over protection system -5- . Tightening torque →

Tightening torque: 45 (33 ftlb Nm

Diagnostic system: reading out fault memory and activating systems

Installing frame for roll-over protection system

2939

Locking plug connection

5. Press in plug connections -1- on wire harness for roll-over protection

system.

Diagram of frame for roll-over protection system

Installation Location:

Diagram of frame for roll-over protection system

1

- Frame for roll-over protection system

2

- Rear side panel lid

3

- Rear three-point belt

4

- Mount for rear hardtop locking mechanism

5

- Roll-over bar module

6

- Angular screwdriver (tool kit)

7

- Convertible-top fixing device

8

- Hydraulic pump

9

- DME control module

10

- Motor for convertible-top compartment lid drive mechanism

11

- Convertible-top compartment lid drive gear

Diagnostic system: reading out fault memory and activating systems

Diagram of frame for roll-over protection system

2940