|
|
Installing seat-belt tensioner Note The seat-belt tensioner may only be installed with the ground terminal of the vehicle battery • The vehicle battery may only be re-connected after the re-installation of the belt has been completed. • 1. Install belt tensioner. Observe the direction of travel. 2. Tighten fastening screw -arrow B- . Tightening torque → Tightening torque: 50 (37 ftlb.) Nm +/-10 % Locking plug for seat-belt tensioner 3. Insert electrical plug -2- in the seat-belt tensioner -arrow A- . 4. Using a screwdriver, for example, push the fuse in, in -direction of arrow- ,until it engages. 5. By gently pulling on the belt -1- , check the winding ability of the belt strap. Installing deflector 6. Position the deflector -2- and the seat belt on the inner side section and screw tight with the Diagnostic system: reading out fault memory and activating systems Installing three-point belt with seat-belt tensioner 2821 |