|
|
Heating the rear lid 1. Heating the rear lid 1.1. Heat the rear cover -1- in the area of the logo -2- using the hot-air gun v.a.g 1416 -3- . Levering off logo 2. Lifting up the logo using a plastic wedge 2.1. Move a plastic spatula -1- under the logo -2- and lift it up. Clean the cover 3. Clean the cover 3.1. Loosen the adhesive residue -1- on the cover -2- using a silicone remover and remove it. Replacing model logo Diagnostic system: reading out fault memory and activating systems Removing the rear logo 2649 |