|
|
Pushing connector onto lid-release motor 1. Push connector onto lid-release motor until it is felt to engage. Tightening fastening screws on lid-release switch 2. Push in lid-release motor under the rear panel -Arrow A- . 3. Engage lid-release motor on lock peg -Arrow B- and slide into the two slots on rear panel -Arrow C- . 4. Secure lid-release motor with the two fastening screws -1- . → Tightening torque: 1 ftlb. Subsequent work Subsequent work Install air cleaner housing . → 23 Removing and installing air cleaner housing - installing 997110, 997111, 997120, 997121, 997310, 997311, 997320, 997321, 997410, 997411, 997430, 997431, Diagnostic system: reading out fault memory and activating systems Installing rear-lid release motor 1865 |