Porshe 911 (997). Manual - part 1107

Danger of material damage if specified curing time of adhesive is not observed!

There will not be a proper adhesive bond if the prescribed curing time of the adhesive is not
observed!

• 

→ The vehicle must not be used until the curing time has elapsed.

→ Curing time: 3 hours

→ Temperature: at least 10°C

→ Fixing time: approx. 1 hour

Safety instructions for installation work

Safety instructions for airbag system

ATTENTION

Danger of injury due to unintentional activation of airbag units!

Serious injury due to unintentional activation of airbag units!

• 

→ The ground strap of the battery must be disconnected during work on the airbag system and

alignment bench jobs when the body is being repaired!

→ After the battery is disconnected, assembly work or work on the vehicle with a hammer or similar

tools must not be started until after a waiting period of 1 minute!

Safety instructions for sliding roof

ATTENTION

Danger of material damage to seats!

Danger of damage to the seats during the removal and fitting of the sliding roof frame!

• 

→ Fold the rear seat assembly forward and tip the front seat backrest backwards during the removal and

fitting of the sliding roof frame.

Diagnostic system: reading out fault memory and activating systems

Material damage when inserting the glass into car windows

4585

ATTENTION

Damage to rear water drainage channel or sliding roof mechanism!

Damage to rear water drainage channel or to the sliding roof mechanism when the sliding roof
panel is removed and when moving the sliding/tilting roof trim.

• 

→ The sliding roof frame must not be moved to the "Open" position when the sliding roof panel has been

removed.

→ The sliding/tilting roof trim must be shifted without the use of force.

Safety instructions for the heat shield

ATTENTION

The installation of deformed heat shields will cause damage!

The installation of deformed heat shields will cause damage due to parts heating up!

• 

→ Damaged or distorted heat shields must be straightened or replaced.

→ Check heat shields for deformation, fixing of the aluminium braided cord, tears and missing or damaged

fixing tabs.

→ After fitting the bumper, check heat shields and aluminium braided cord for leaks.

997110, 997111, 997120, 997121, 997310, 997311, 997320, 997321, 997410, 997411, 997430, 997431,
997610, 997611, 997620, 997621

WARNUNG

Gefahr des Verlusts der Text-Bild-Zuordnung beim Ausdruck.

Aus technischen Gründen kann derzeit nicht ausgeschlossen werden, dass trotz
einwandfreier Darstellung auf dem Bildschirm beim Ausdruck der
Zusammenhang von Text und zugehörigem Bild verloren geht.

• 

Wird der Fehler nicht bemerkt, besteht die Gefahr, daß Arbeiten nicht korrekt
durchgeführt werden und es dadurch zu Personen- und Sachschäden kommt.

• 

→ Vergleichen Sie deshalb nach dem Druckvorgang unbedingt die Ausdrucke mit der
Bildschirmdarstellung. Korrigieren Sie die Ausdrucke im Fehlerfall so, daß der Inhalt der
Bildschirmdarstellung zutreffend wiedergegeben wird.

Diagnostic system: reading out fault memory and activating systems

Safety instructions for sliding roof

4586

WARNING

Danger of losing text-figure correspondence when printing out.

For technical reasons, it can currently not be ruled out that the correspondence
between text and associated figure can be lost when it is printed out, even though
the display on the screen is correct.

• 

If the fault is not noticed, there is the danger that work will not be performed
correctly which can cause injury and damage.

• 

→ Therefore, always compare printouts with the screen display after printing them out. Correct
the printouts if they are faulty so that the content of the screen display matches that on the
printouts.

AVERTISSEMENT

Risque de perte de la correspondance texte-illustration lors de l'impression papier.

Pour des raisons techniques, il ne peut pas être exclu à l'heure actuelle que, même
en cas d'affichage correct à l'écran, la correspondance entre le texte et l'illustration
puisse être erronée sur l'impression papier.

• 

Si l'erreur passe inaperçue, on court le risque d'exécuter certaines opérations de
manière incorrecte pouvant conduire à des dommages corporels et matériels.

• 

→ Comparez impérativement pour cette raison les impressions papier avec l'affichage à l'écran.
Corrigez-les en cas d'erreur de manière à reproduire correctement l'affichage à l'écran.

ATTENZIONE

Pericolo di perdita dell'abbinamento testo-immagine nella stampa.

Per motivi tecnici non è escluso che, nonostante la rappresentazione sullo schermo
risulti perfetta, durante la stampa venga persa la corrispondenza fra testo e
relativa immagine.

• 

Se tale difetto non viene rilevato vi è il pericolo che i lavori non siano eseguiti
correttamente; ciò può avere come conseguenza lesioni e danneggiamenti.

• 

→ Per questo motivo, dopo la stampa è assolutamente necessario confrontare le stampe con la
rappresentazione sullo schermo. In caso di errore si prega di correggere le stampe, così da
garantire la riproduzione esatta della rappresentazione sullo schermo.

ADVERTENCIA

Al imprimir se corre el riesgo de perder la correcta asignación de las figuras al texto.

Por motivos técnicos, por el momento no se puede descartar que, aun siendo
correcta la imagen que aparezca en la pantalla, al imprimir se pierda la
correlación entre el texto y la figura correspondiente.

• 

Si este error pasara desapercibido, existe el riesgo de que los trabajos no se
ejecuten de forma correcta y, por tanto, se produzcan daños personales y

• 

Diagnostic system: reading out fault memory and activating systems

Safety instructions for the heat shield

4587

materiales.

→ Por ello le rogamos que tras el proceso de impresión compare siempre las copias impresas con
la imagen de la pantalla. En caso de error, corrija las copias impresas de forma que se
correspondan con el contenido de la imagen de la pantalla.

Diagnostic system: reading out fault memory and activating systems

Safety instructions for the heat shield

4588