|
|
ENGINE OVERHAUL 21 Cylinder head - refit 1. Clean cylinder head bolt threads, replace any bolt showing signs of wasting or corrosion. 2. Screw each cylinder head bolt by hand into bolt holes in cylinder block. 3. Clean any tight threads using an M11 x 1.5 tap. of oil and dirt are removed 5. Check that oil restrictor if it is to be fitted is clear and fitted below face of cylinder block:- 6. Ensure 2 nylon locating dowels are fitted in cylinder block. 7. Remove all traces of oil from cylinder block and cylinder head; position new, dry gasket on 8. Ensure timing pin LRT-12-058 is inserted in hole in flywheel. NOTE: If flywheel is not fitted, rotate 9. Fit cylinder head ensuring it is located on dowels. 10. Apply a light film of oil to bolt threads and underside of heads. |